Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 51)

Chapter 2
Operating the Control
2-31
To enter a password, follow these steps:
1. Press the {PASSWORD} softkey.
(softkey level 1)
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
You see the password log-on screen:
ACCESS
CONTRL
ENTER PASSWORD:
PROGRAM [INCH] F 0.000 MMPM
Z 00000.000 S 0
R X 00000.000 T 1
C 359.99
MEMORY MAN STOP
E-STOP
The prompt “ENTER PASSWORD:” appears on line 2 of the CRT.
2. Enter the password. The control displays only * for the characters
entered. If you make an error entering the password, edit the input
line as described on page 2-41.
3. When the password is correct, press the [TRANSMIT] key. The access
level that the password is assigned to is made active, and the control
enables all of the functions that are assigned to that access level.