5 program search {search – Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 198

Running a Program
Chapter 7
7-10
Use the program search feature to begin program execution from some
block other than at the beginning of the program. This feature requires the
operator to establish the necessary G, M, S, F, and T words, work
coordinate offsets, etc. that should be active for that block’s execution.
The control can start a program at a chosen block and establish any
previous G, M, S, F, and T words, work coordinate offsets, etc., that were
established in previous blocks using the search with memory feature. For
details, see page 7-6 for automatic execution.
The program search feature is not effective for subprograms and
paramacros. You can search only blocks that are in the main program.
To perform a program search operation:
1.
Press the
{PRGRAM MANAGE}
softkey. The program to search must
have previously been selected for automatic execution as described
on page 7-6.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
2.
Press the
{ACTIVE PRGRAM}
softkey.
REFORM
MEMORY
CHANGE
DIR
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
7.5
Program Search {SEARCH}