2 selecting a part program input device – Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 193

Running a Program
Chapter 7
7-5
Before selecting a part program, you must tell the control where this part
program is currently residing. You have 3 options:
the program can reside in the control’s memory
the program can reside on a peripheral device attached to port A such as
a tape reader (see your system installer’s documentation)
the program can reside on a peripheral device attached to port B such as
a tape reader (see your system installer’s documentation)
Important: If selecting a peripheral device attached to one of the two
communication ports (A or B), that port must have previously been
configured to communicate to that specific peripheral device. See chapter
9 for details on communications setup for ports A and B. Selecting a
program from the control’s memory is the default configuration of the
control. If port A or B is never selected, the input device should remain at
its default of control memory and the following procedure should be
unnecessary.
To select the part program input device:
1.
Press the
{PRGRAM MANAGE}
softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
2.
Press the
{INPUT DEVICE}
softkey.
REFORM
MEMORY
CHANGE
DIR
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
7.2
Selecting a Part Program
Input Device