Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 197)

Running a Program
Chapter 7
7-9
To select a different part program for automatic execution, you must
deactivate the part program that is currently active. To do this, follow
these steps:
1. Press the {PRGRAM MANAGE} softkey. The control displays the
program directory screen as shown in Figure 7.2.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
If you see an: To the right of the program name, it means that the program is:
A currently active
E currently being edited
Figure 7.2 shows program TEST as active and being edited.
2. Press the {ACTIVE PRGRAM} softkey. The control displays the first
few blocks of the currently active program.
REFORM
MEMORY
CHANGE
DIR
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
3. If the program selected is not the desired active program, press the
{DE-ACT PRGRAM} softkey. The control deactivates the part program
and returns to the directory screen.
(softkey level 3)
DE-ACT
PRGRAM
SEARCH MID ST
PRGRAM
T PATH
GRAPH
SEQ
STOP
TIME
PARTS
7.4
De-Selecting a Part Program