Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 664

Paramacros
Chapter 20
20-20
Value of Parameter
Result
0
Single block mode can be activated and M-codes are executed at the
beginning of the program block’s execution.
1
Single block mode requests are ignored and M-codes are executed at
the beginning of the program block’s execution.
2
Single block mode can be activated and M-codes are executed after
the complete execution of the other commands in the block.
3
Single block mode requests are ignored and M-codes are executed
after the complete execution of the other commands in the block.
#3004
Block Execution Control 2
Use this parameter to determine whether a cycle stop request is recognized,
whether the feedrate override switch is active, and whether exact stop
mode is available (G61 mode). The range of this parameter is from 0 to 7
and it is a write-only parameter.
Table 20.F shows the results of the different values for parameter #3004.
If cycle stop, feedrate override, or exact stop mode is ignored, the control
does not allow the feature to be used. If they are recognized, the feature
can be activated in the normal manner.
Table 20.F
Parameter 3004 Values
Value of Parameter
Cycle Stop
Feedrate Override
Exact Stop Mode
0
Recognized
Recognized
Recognized
1
Ignored
Recognized
Recognized
2
Recognized
Ignored
Recognized
3
Ignored
Ignored
Recognized
4
Recognized
Recognized
Ignored
5
Ignored
Recognized
Ignored
6
Recognized
Ignored
Ignored
7
Ignored
Ignored
Ignored