Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 229)

Displays and Graphics
Chapter 8
8-9
{TARGET}
The coordinate values of the end point of the currently executing axis
move is displayed at a position in the current work coordinate system.
Figure 8.7
Results After Pressing {TARGET} Softkey
TARGET[ MM ] F 0.000 MMPM
X -7483.647 S 00
Z -7483.647 T 0
U -7483.647 (ACTIVE PROGRAM NAME)
MEMORY MAN STOP
PRGRAM A B S TARGET D T G AXIS
SELECT
E-STOP