Communications – Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 261

Chapter
9
9-1
Communications
This chapter contains this information:
Topic:
On Page:
Setting Communications
9-1
Setting Communication Port Parameter Values
9-1
Communication Port Parameters
9-3
Inputting Part Programs from a Tape Reader
9-9
Outputting Part Programs to a Tape Punch
9-13
Verifying Part Programs Against Source Programs
9-16
Error Conditions (Inputting and Outputting Part Programs)
9-18
This section covers the communication port parameters that are available
with the control. You use communication parameters to let the control
communicate with peripheral devices.
The control has default parameters permanently stored in memory for a
number of peripheral devices. These devices are listed in Table 9.A and
are selected by the DEVICE parameter. You can also modify the default
parameters separately for each device.
This section describes how to change communication parameter values. A
description of each of the parameters is presented on page 9-3.
Display the device setup screen as follows:
1.
Press the {SYSTEM SUPORT} softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
9.0
Chapter Overview
9.1
Setting Communications
9.1.1
Setting Communication Port
Parameter Values