Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual
Page 146

Editing Programs On Line
Chapter 5
5-26
If you have configured a surface grinder, this screen appears:
SELECT
E-STOP
GRINDER PROMPT MENU
DISPLAY
.
G80
CANCEL OR END FIXED CYCLE
G81
RECIPROCATION
G81.1
RECIPROCATION PREDRESS
G82
PLUNGE
G82.1
PLUNGE PREDRESS
G83
INCREMENTAL PLANE 1
G83.1
INCREMENTAL PLANE 1 PREDRESS
G84
INCREMENTAL PLANE 2
G84.1
INCREMENTAL PLANE 2 PREDRESS
G85
CONTINUOUS PLANE 1
G85.1
CONTINUOUS PLANE 1 PREDRESS
G86
CONTINUOUS PLANE 2
G86.1
CONTINUOUS PLANE 2 PREDRESS
2.
Position the cursor at the desired cycle to prompt by using the up and
down cursor keys. The selected G code cycle appears in reverse
video.
3.
Once you select the correct cycle code, press the
{SELECT}
softkey.
The control displays a screen with prompts for that cycle along with a
graphical representation of the cycle.
4.
Use the up and down cursor keys to select the parameters you want to
change or enter. The selected parameter appears in reverse video.
Axis words followed by a (1), (2), or (3) are prompting for the first,
second, or third coordinate position respectively. The location of the
first, second, or third axis word appears on the drawing
accompanying the prompt screen.
Prompts that appear in reverse video indicate that this parameter is
optional and need not be entered in this block. Prompts that appear
with an OR to the left of the prompt indicate that there are two or
more optional parameters for this prompt; only one of them must
have a value assigned to it.
5.
Type in the data for that parameter on the input line of the CRT and
press the
[TRANSMIT]
key.