Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set - Manual (Page 590)

Cylindrical Grinding Fixed Cycles
Chapter 17
17-16
The format for the G83 cycle is as follows:
G18;
G83Z__K__X__I__Q__L__F__E__P__D__;
Table 17.C summarizes the G83 cycle parameters. For a detailed
description of these parameters, see the text below and page 17-9.
Table 17.C
G83 Cycle Parameters
Parameter: Definition: Default Value: Possible Value:
Plane axis 1 2 reciprocation primary reversal point from last cycle programmed abs. or inc.
Plane axis 1 integrand 3 reciprocation secondary reversal point start point abs. or inc.
Plane axis 2 1 plunge depth value must be programmed abs. or inc.
Plane axis 2 integrand 1 plunge pick at primary reversal point value must be programmed inc. only
Q 3 plunge pick at secondary reversal point plunge pick at primary reversal inc. only
L 3 number of spark-out passes zero zero to 999
F 2 plunge pick feedrate last feedrate programmed valid F word
E 3 reciprocation feedrate from last cycle or last F valid F word
P 3 for G83 2 for G83.1 dress program number from last cycle programmed valid program number
D 3 number of auto-dress executions zero zero to 999
1 must be programmed 2 must have been programmed in some previous block if omitted 3 optional
Figure 17.4 shows the axis motions that make up the G83 incremental
plunge grinding cycle. This figure assumes that the ZX plane (G18) is
active.
17.5
G83 or G83.1 Incremental
Plunge Grinding (Axis 2)