Rockwell Automation 8520-GUM 9/Series CNC Grinder Operation and Programming Manual Documentation Set User Manual

Page 195

Running a Program

Chapter 7

7-7

Figure 7.2

Part Program Directory

ACTIVE

PRGRAM

EDIT

PRGRAM

RESTRT

PRGRAM

DISPLY

PRGRAM

COPY

PRGRAM

SELECTED PROGRAM:

MAIN

DIRECTORY

PAGE

NAME

SIZE

COMMENT

TEST

3.9

O12345

1.3

SUB TEST 1

MAIN

1.3

SHAFT2

1.3

THIS IS A TEST PROGRAM

XXX

1.3

5 FILES

137.8 METERS FREE

Important: Figure 7.2 shows program TEST as active and being
edited. Make sure no part program is currently active. If a part
program is currently active, the control does not allow the selection of
a different part program until the currently active one is deactivated
(see page 7-9 on deactivating a part program).

If you see an:

To the right of the program name, it means that the program is:

currently active

currently being edited

Select the directory that contains the program to activate. You can
select either the main directory or the protectable directory. The
control displays the main directory as the default directory at
power-up. You must select the protectable directory by using the

{CHANGE DIR}

softkey.

Important: The

{CHANGE DIR}

softkey controls access to the

protectable part program directory. The

{CHANGE DIR}

softkey is

password protected. You must have the proper password to access
this softkey. See page 5-42 for additional information on the
protectable directory and the

{CHANGE DIR}

softkey.