HP Integrity NonStop H-Series - Manual (Page 375)

Running CNFGINFO
DSM/SCM User’s Guide — 529846-014
C - 2
Preparing to Run CNFGINFO
Preparing to Run CNFGINFO
To run CNFGINFO, the file CNFGI.EXE must be installed on a PC with a Winsock
connection to a NonStop host system. (See
Section 5, Configuring DSM/SCM .) If you
are running CNFGINFO outside DSM/SCM, you must run the server program file
CNFGINFO from the ZDSMSCM subvolume using these parameters: NOWAIT, NAME
$ZPHC, TERM, IN, and OUT. The server will be running if the full DSM/SCM product is
installed and you have run STARTSCM from the ZDSMSCM subvolume.
Before you run CNFGINFO:
1. Place the appropriate product files in a DSV:
2. Check that you have access to the needed A0CINFO files:

You must have read access to view an A0CINFO file. Otherwise, you receive
an error message when you try to open it.

To modify or create an A0CINFO file, you must have read access to the files in
the DSV and read, write, and purge access to the A0CINFO file.
Normally, purge access is required to modify the A0CINFO file. To modify an
A0CINFO file without purge access, set the CNFGINFO-NO-PURGE option to
ON:
> STOPSCM ( or STOPCFG)

> PARAM CNFGINFO-NO-PURGE ON

> STARTSCM ( or STARTCFG)

Any new A0CINFO files you create have the ownership and security attributes
of the user ID under which you logged on.
Scenario Files to be put in the DSV
Defining a new application (product) All product files
Defining a new revision to your product All product files for the new revision
Defining a base SPR for your product All product files

(A base SPR contains all files for a product
though only a few files might have changed.)
Defining an update SPR for your product Only the changed files