HP Integrity NonStop H-Series - Manual (Page 235)

Troubleshooting
DSM/SCM User’s Guide — 529846-014
13 - 10
DSM/SCM Configuration Troubleshooting
DSM/SCM Configuration Troubleshooting

INITENV does not change a site’s existing TMF configuration and does not detect
whether the audit trail is big enough. However, the configuration in use might not
be adequate. INITENV creates audit trails large enough for 118 megabytes of
audit.

When applying DSM/SCM to DSM/SCM, always use the original TSV.
If you configured INITENV to use a direct Winsock interface between the system and
the Planner Interface on your PC, INITENV looks for the LISTNER program on the
current SYSnn subvolume. If INITENV cannot find LISTNER, it prompts you to:

Use Winsock.
Either install TCP/IP, or press Ctrl-Y to exit INITENV. After installing TCP/IP, rerun
INITENV and specify that you will use a Winsock connection.

Continue even though the LISTNER program is not on the system.
INITENV asks if it can modify the DSM/SCM Winsock service by modifying the
SERVICES and PORTCONF files:

If you answer no, INITENV displays the steps you must manually perform and
skips the Winsock setup.

If you answer yes, INITENV prompts for the location of the SERVICES and
PORTCONF files. INITENV then prompts for the IP port for the DSM/SCM
Winsock service. You must specify the same port when you later run SETUP.
Before running STARTSCM, INITENV checks if a TCP/IP process is running:
INITENV then checks to see if a LISTNER process is running:
Processes
Running
INITENV Response
More than
one Warns you to stop and restart the LISTNER process that corresponds to the
IP address and port number specified during SETUP on the PC
None Prompts you to either start TCP/IP now or start it and its LISTNER process
before using the Planner Interface
Processes
Running LISTNER is in SYSnn, and super
ID (255,255) is running INITENV
INITENV Response
More than
one Yes Warns you to stop and restart the
LISTNER process that corresponds to
the IP address and port number
specified during SETUP on the PC
None Yes Tries to start the LISTNER process
None No Prompts you to have the super ID start
the LISTNER process now or after
DSM/SCM starts.