HP Integrity NonStop H-Series - Manual (Page 89)

Configuring DSM/SCM
DSM/SCM User’s Guide — 529846-014
5 - 4
Task 1: Changing Default Settings Using INITENV

Change the DSM/SCM hometerm.

Change the DSM/SCM server priority.
To change the default settings:
1. Make sure that you have a unique system name and number. See Changing the
System Name and Number on page 5-2.
2. Log on to your system as the super ID (255,255) or as the DSM/SCM user ID.
> logon 255.255
password:
3. Make ZDSMSCM the current subvolume:
> VOLUME $volume.ZDSMSCM
4. Check that TMF is running:
> TMFCOM START TMF
5. Check that DSM/SCM is not running:
> RUN STOPSCM
For more information, refer to Starting and Stopping DSM/SCM on page 2-2.
6. Run INITENV and select the change option:
> RUN INITENV
Use Table 5-1 as a quick guide to configure a host or physical target system. The
right column provides common entries. For this procedure, make sure that you
select C when INITENV asks if you are initializing or changing the system.
Table 5-1. Changing Default Settings Checklist (page 1 of 2)
Question Enter
___ Would you like to read the introduction? Y or N
___ Is this the name and number you want for this system?

If the displayed system name and number are
correct, no change is necessary.

If the displayed system name and number are not
correct, break out of INITENV (CTRL-Y), and see
Changing the System Name and Number on
page 5-2.
Y or N
___ Are you changing or initializing the system? C
___ Host or physical target system? Host or Target
___ Want to change host system for this target system?
This is displayed only if the system is a target system.
Y or N