HP Integrity NonStop H-Series - Manual (Page 107)

Configuring DSM/SCM
DSM/SCM User’s Guide — 529846-014
5 - 22
Creating an Alternate System Disk
Creating an Alternate System Disk
1. Prepare and rename the volume using the subsystem control facility (SCF). See
these manuals:

NonStop NS-Series Hardware Installation Guide

NonStop S-Series Hardware Installation and Fast Path Guide
2. Run Verify Database from the ZPHITI. See Verifying the Target System Database
(ZPHITI) on page 17-18.

If the volume was a scratch volume, Verify Database will stop in restartable
mode, issuing an EMS message that no scratch volumes are configured on the
target system. Define at least one scratch volume using the ZPHITMI. Then
restart the Verify Database activity. After successful completion of Verify
Database, update the volume usage information using the ZPHIHMI.

If the volume was an archive volume, update the volume usage information
using the ZPHITMI and ZPHIHMI after successful completion of Verify
Database. See
Updating the Volume Usage on page 17-11
3. Create an independent snapshot. See Creating an Independent Snapshot of the
Target System on page 17-19.
4. Add a logical target for the alternate system disk, including performing a
Build/Apply to the new logical target. See Adding a Logical Target on page 5-17.
5. For the remaining steps, return to these manuals:

NonStop NS-Series Hardware Installation Guide

NonStop S-Series Hardware Installation and Fast Path Guide