HP Integrity NonStop H-Series - Manual (Page 213)

Activating New Software on a Target System
DSM/SCM User’s Guide — 529846-014
10 - 6
Example: Planner Instructions to Operator
8. RUN INSTALL^TEMPLATES to update EMS template files.
EMS templates format EMS messages. The Run INSTALL^TEMPLATE instruction
is generated only on the basis of product files present in the software configuration.
If you change the software configuration to include products that force system
generation, DSM/SCM directs a system generation program to run TEMPLI,
ensuring installation of the user template specified in the CONFTEXT file.
To run the INSTALL^TEMPLATES program to install the EMS templates in their
proper locations:
a. Set the volume and subvolume to $SYSTEM.ZINSAIDS.
b. Load the TACLMACS file.
c. Enter the command INSTALL^TEMPLATES.
9. DOWN/STOP any DEVICE/LINE using filename.

Use SCF to STOP these DEVICES/LINES, and then to start them
again.

product number product name includes IOP OBJECT code changes .
If one or more input/output processes (IOP) files change in this configuration
revision but does not require system generation and one or more (IOPs) have
changed, use SCF to:
a. Stop all devices and lines that use the IOP file.
b. Restart the devices and lines to put the new IOP file into effect. For more
information, refer to the SCF Reference Manual for G-Series RVUs or SCF
Reference Manual for J and H-Series RVU.
10.Restart all applications.

Use the TI to complete any necessary DSM/SCM activities.
The last step in activating the new software is to restart all the applications you
stopped in Step 1.
Note. DSM/SCM decides whether a system generation program should run TEMPLI
based on the product files in the software configuration on which Build/Apply is performed.
If you add the user template to the CONFTEXT file but keep the same configuration,
DSM/SCM does not run TEMPLI through system generation or generate the operator
instruction Run INSTALL^TEMPLATE. As a result, the user template is not installed.