Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 592)

L-force | PLC Designer
Compiler Errors and Warnings
590 DMS 3.2 EN 02/2011 TD29
3503
"Wrong data type for '' in 'VAR_CONFIG'"
In the global variables list which contains the ‚Variable_Configuration’ the variable is
declared with a different address than in the POU.
3504
"Initial values are not supported for 'VAR_CONFIG"
A variable of the ‚Variable_Configuration’ is declared with address and initial value.
But an initial value can only be defined for input variables without address
assignment.
3505
"’’is no valid instance path"
The Variable_Configuration contains a nonexisting variable.
3506
"Access path expected"
In the global variable list for Access Variables the access path for a variable is not
correct. Correct: :'': .
3507
"No address specification for 'VAR_ACCESS'-variables"
The global variable list for Access Variables contains an address assignment for a
variable. This is not allowed.
Valid variable definition: :'':
3550
"Duplicate definition of identifier ''"
There are two tasks are defined with an identic same name. Rename one of them.
3551
"The task '' must contain at least one program call"
Insert a program call or delete task.