Lenze PLC Designer PLC Designer (R2-x) - Manual (Page 542)

L-force | PLC Designer
Command Line-/Command File
540 DMS 3.2 EN 02/2011 TD29
Commands for the control of replace of objects respectively for the control of files for
import, export, copy:
replace yesall Replace all (any 'query on' command will be ignored; no dialogs will
open)
replace noall Replace none (any 'query on' command will be ignored; no dialogs
will open)
replace query If a 'query on' command is set, then a dialog will open regarding the
replacing of the objects even if there is a 'replace yesall' or 'replace
noall' command
Commands for the control of the default parameters of PLC Designer dialogs:
query on Dialogs are displayed and need user input
query off ok All dialogs respond as if the user had clicked on the 'OK' button
query off no All dialogs respond as if the user had clicked on the 'No' button
query off cancel All dialogs respond as if the user had clicked on the 'Cancel' button
Command for calling command files as subprograms:
call ...
Command files will be called as subprograms. Up to 10 parameters
may be passed. In the file that is called, the parameters can be
accessed with $0 - $9.
call ...
Command files are called as subroutines. Up to ten parameters can
be consigned. In the subroutine called you can access the
parameters using $0 - $9.
Setting of directories used by »PLC Designer«: ( -> project options dialog, category
'Directories', subcategory 'General'):
If several directories are defined with one of the following commands, these must be
separated by a
semicolon + emptyspace and the whole row of directories must be embraced by
double quotation marks.
Example, two pathes:
dir lib "D:\plcdesigner\Libraries\Standard;
D:\plcdesigner\Libraries\NetVar"
dir lib Sets as the library directory
dir compile Sets as the directory for the compilation files
dir config Sets as the directory for the configuration files
dir upload Sets as the directory for the upload files