Allied Telesis AT-DC2552XS - Manual (Page 92)

Chapter 4: Basic Switch Operations Commands
92 Section I: Switch Management
BOOT SYSTEM
Syntax
boot system file_name .img
Parameter
file_name .img
Specifies the name of a management software image file that the
switch uses when the system is rebooted or reloaded. The file
name must have an “img” extension.
Mode
Global Configuration mode
Description
Use this command to specify the name of a management software image
file that the switch uses when the system is rebooted or reloaded.
Note
The setting of this command is stored directly in the boot setting that
the bootloader uses. You do not need to use the COPY or WRITE
command to save this setting.
Example
This example sets the DC2552-1.2.img file as the management software
file that will be used when the system is rebooted or reloaded:
awplus> enable
awplus# configure terminal
awplus(config)# boot system DC2552-1.2.img