Allied Telesis AT-DC2552XS - Manual (Page 308)

Chapter 13: VLAN Commands
308 Section II: Layer 2 Switching
NO SWITCHPORT ACCESS VLAN
Syntax
no switchport access vlan
Parameters
None
Mode
Port Interface mode
Description
Use this command to return untagged ports on the switch to the default
value of VLAN 1.
This command is equivalent to the SWITCHPORT ACCESS VLAN
command with a VID of 1 specified. See “SWITCHPORT ACCESS VLAN”
on page 318.
Confirmation Command
“SHOW VLAN” on page 314
Example
This example returns port 1.0.5 to the default value of VLAN 1:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.5
awplus(config-if)# no switchport access vlan