Length – Allied Telesis AT-DC2552XS User Manual
Page 44
Chapter 2: Management Session Commands
44
LENGTH
Syntax
length
length
Parameter
length
Specifies the maximum number of lines that the SHOW commands
display on the screen at once. The range is 0 to 512 lines. Assign a
value of 0 if you do not want the SHOW commands to pause. The
default value is 20 lines.
Mode
Console Line and Virtual Terminal Line modes
Description
Use this command to specify the maximum number of lines that the
SHOW commands display on the screen at once. You can set different
values for the local and remote management sessions with this command.
For local management sessions, enter the command in the Console
line mode.
For remote Telnet and SSH sessions, enter the command in the Virtual
Terminal Line (VTY) mode.
If the maximum numbers of lines are set by the TERMINAL LENGTH or
SERVICE TERMINAL-LENGTH command, the switch uses these settings
to display output. Here is the priority of the commands, listing the highest
priority command first:
1. The TERMINAL LENGTH command
2. The SERVICE TERMINAL-LENGTH command
3. The LENGTH command
Confirmation Command