Allied Telesis AT-DC2552XS - Manual (Page 232)

Chapter 10: NTP Client Commands
232 Section I: Switch Management
NTP PEER
Syntax
ntp peer ipaddress
Parameter
ipaddress
Specifies an IP address of an NTP server.
Mode
Global Configuration mode
Description
Use this command to activate the NTP client on the switch and to specify
the IP address of the NTP server. The switch obtains its date and time
from the NTP server. You can specify only one NTP server. After you
enter this command, the switch automatically begins to query the network
for the defined server.
Confirmation Command
“SHOW NTP ASSOCIATIONS” on page 234
Example
This example activates the NTP client on the switch and defines the IP
address of the NTP server as 172.17.28.251:
awplus> enable
awplus# configure terminal
awplus(config)# ntp peer
172.17.28.251