Allied Telesis AT-DC2552XS - Manual (Page 313)

AT-DC2552SX Switch Command Line Interface User’s Guide
Section II: Layer 2 Switching 313
NO VLAN MACADDRESS (Port Interface Mode)
Syntax
no vlan vid macaddress mac-address
Parameters
vid
Specifies the VID of a MAC address-based VLAN. The MAC
address-based VLAN must already exist.
mac-address
Specifies the MAC address. You can specify only one address.
The MAC address must be entered in the hexadecimal format:
xx:xx:xx:xx:xx:xx
Mode
Port Interface mode
Description
Use this command to remove a MAC address from egress ports assigned
to MAC address-based VLANs. You can remove only one address at a
time with this command.
Confirmation Command
“SHOW VLAN MACADDRESS” on page 316
Example
This example removes the MAC address 00:30:84:32:8A:5D from egress
ports 1.0.1 through 1.0.10 in a VLAN that has a VID value of 4:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.1-1.0.10
awplus(config-if)# no vlan 4 macaddress 00:30:84:32:8a:5d