Channel-group – Allied Telesis AT-DC2552XS User Manual
Page 282
Chapter 12: LACP Commands
282
CHANNEL-GROUP
Syntax
channel-group
id_number
Parameter
id_number
Specifies the ID number of a new or an existing LACP trunk group.
The range is from 1 to 65,335.
Mode
Port Interface mode
Description
Use this command to create a new LACP trunk group (dynamic trunk
group) or to add ports to existing LACP channel group. You can create up
to 32 trunk groups on the switch, including the dynamic LACP and static
trunk groups.
To create a new LACP trunk group or add ports to an existing LACP trunk
group, the member ports must belong to the same VLAN and have the
same switchport mode: either access or trunk.
The lowest numbered port in an LACP trunk group is called the base port.
When adding ports to an existing LACP trunk group, you cannot add ports
that are below the base port. For example, you cannot add ports 1.0.1 to
1.0.6 to an existing LACP trunk group that consists of ports 1.0.7 to 1.0.12.
Instead, you must delete and recreate a trunk group to change its base
port.
Confirmation Command
“SHOW ETHERCHANNEL” on page 288
Examples
This example creates a new LACP trunk group consisting of ports 1.0.11
through 1.0.16. The ID number of the LACP trunk group is 2:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.11-port1.0.16
awplus(config-if)# channel-group 2