Lacp system-priority – Allied Telesis AT-DC2552XS User Manual
Page 284
Chapter 12: LACP Commands
284
LACP SYSTEM-PRIORITY
Syntax
lacp system-priority
priority
Parameter
priority
Specifies the LACP system priority value for the switch. The range
is 1 to 65,535. By default, the priority value for the switch is 32,768.
The value of 1 has the highest priority.
Mode
Global Configuration mode
Description
Use this command to change the LACP priority of the switch. The switch
uses the LACP priority to resolve conflicts with other network devices
when the switch creates LACP trunk groups. The settings on the device
with the higher priority takes precedence over the settings on the partner
device. If both devices have the same LACP system priority value, the
settings on a device that has the lower MAC address takes precedence.
To set the LACP system priority value to the default value of 32,768, use
the NO LACP SYSTEM-PRIORITY command.
Confirmation Command
“SHOW LACP SYS-ID” on page 295
Example
This example assigns a system priority of 200 to the switch:
awplus> enable
awplus# configure terminal
awplus(config)# lacp system-priority 200