Allied Telesis AT-DC2552XS - Manual (Page 428)

Chapter 19: IGMP Snooping Commands
428 Section IV: IPv4 Multicast
IP IGMP QUERIER-TIMEOUT
Syntax
ip igmp querier-timeout timeout
Parameter
timeout
Specifies the time period, in seconds, used by the switch to delete
host entries and multicast router entries when they time out. The
range is from 0 to 86,400 seconds (24 hours). The default is 260
seconds. Setting the timeout to zero (0) disables the timer.
Mode
Global Configuration mode
Description
Use this command to specify the time period the switch uses to delete
host and multicast router entries. The time period is in seconds.
A host node multicast router is deemed inactive and its entries on the
switch are deleted if the switch does not receive IGMP reports or queries
from the host or router for the duration of the timer.
Confirmation Command
“SHOW IP IGMP” on page 434
Example
This example sets the timeout for host entries and multicast router entries
to 400 seconds:
awplus> enable
awplus# configure terminal
awplus(config)# ip igmp querier-timeout 400