Allied Telesis AT-DC2552XS - Manual (Page 312)

Chapter 13: VLAN Commands
312 Section II: Layer 2 Switching
NO VLAN MACADDRESS (Global Configuration Mode)
Syntax
no vlan vid macaddress mac-address
Parameters
vid
Specifies the VID of a MAC address-based VLAN. The MAC
address-based VLAN must already exist.
mac-address
Specifies the MAC address. You can specify only one address.
The MAC address must be entered in the hexadecimal format:
xx:xx:xx:xx:xx:xx
Mode
Global Configuration mode
Description
Use this command to remove a MAC address from a MAC address-based
VLAN. You can remove only one address at a time with this command.
MAC addresses cannot be deleted if they are assigned to egress ports. To
remove MAC addresses from egress ports, see “NO VLAN
MACADDRESS (Port Interface Mode)” on page 313.
Confirmation Command
“SHOW VLAN MACADDRESS” on page 316
Example
This example removes the MAC address 00:30:84:32:8A:5D from a MAC
address-based VLAN with a VID value of 4:
awplus> enable
awplus# configure terminal
awplus(config)# no vlan 4 macaddress 00:30:84:32:8a:5d