Allied Telesis AT-DC2552XS - Manual (Page 520)

Chapter 21: Quality of Service (QoS) Commands
520 Section V: Security and Traffic Control
The fields are described in Table 82.
Example
This example displays the QoS settings on port 1.0.3:
awplus# show mls qos interface port1.0.3
Table 82. SHOW MLS QOS INTERFACE Command
Field Description
Interface Displays the port ID.
INPUT-POLICY-MAP-
NAME Displays the name of the policy map assigned
to the port. Information about the policy map,
such as class maps, and matching criteria are
also displayed. It displays the above
information only when the port is assigned to
a policy map.
Default CoS Displays the CoS value set on the port. This
CoS value is assigned only to untagged
frames when received at this port. The CoS
value is only displayed when the value is not
the default value of 0.
Number of egress
queues Displays the number of egress queues on the
port. Each port on the switch has eight
queues.
Egress Queue Displays the egress queue number.
Status Displays the status of the egress queue. The
options are:
 Enabled
 Disabled
Scheduler Displays the scheduler that the egress queue
applies. The options are:
 Strict Priority
 Weighted Round-Robin
Weight Displays the weight specified to the egress
queue. This field is displayed only when the
egress queue's scheduler is WRR.
Queue Limit Not supported.
Egress Rate Limit Displays the maximum egress rate specified
on the port. When the rate is not set, this field
displays 0 Kb.