Allied Telesis AT-DC2552XS - Manual (Page 89)

AT-DC2552SX Switch Command Line Interface User’s Guide
Section I: Switch Management 89
BANNER EXEC
Syntax
banner exec [default]
Parameter
default
Specifies the banner as a default setting, which is the firmware
version number and the host name of the switch.
Mode
Global Configuration mode
Description
Use this command to create a banner that is displayed right after you log
on or clear the screen with the CLEAR SCREEN command.
After you enter the command, the prompt “Type CTRL/D to finish” is
displayed on your screen. Enter a banner message of up to 255
characters. Spaces, special characters except “!” and “?”, and carriage
returns are allowed. When you are finished, hold down the CTRL key and
type D.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 116
Examples
This example creates the banner “Production Switch 1P”:
awplus> enable
awplus# configure terminal
awplus(config)# banner exec
Type CNTL/D to finish
Production Switch 1P
This example sets the banner with the default setting:
awplus> enable
awplus# configure terminal
awplus(config)# banner exec default