Default log – Allied Telesis AT-DC2552XS User Manual
Page 159
AT-DC2552SX Switch Command Line Interface User’s Guide
159
DEFAULT LOG
Syntax
default log buffered|permanent|monitor|console|
host
ipv4_address
Parameters
buffered
Sets the buffered log to the default settings. By default, the
maximum memory size is 50 Kbytes, the filtering condition level is
informational, and logging in the buffered log is enabled.
permanent
Sets the permanent log to the default settings. By default, the
maximum memory size is 50 Kbytes, the filtering condition level is
warning, and logging in the permanent log is enabled.
monitor
Sets the terminal monitor output to the default settings. By default,
the filtering condition level is debugging.
console
Sets the console output to the default settings. By default, the
filtering condition level is critical, and sending event messages to
the console port is enabled.
host
Sets the syslog server output to the default settings. By default, the
filtering condition level is not specified, the time is local, and
sending event messages to the syslog server is disabled.
ipv4_address
Specifies the IPv4 address of the syslog server.
Mode
Global Configuration mode
Description
Use this command to set the specified log to default settings.
Confirmation Command