Allied Telesis AT-DC2552XS - Manual (Page 461)

AT-DC2552SX Switch Command Line Interface User’s Guide
Section V: Security and Traffic Control 461
vid
Specifies the VLAN ID of a receiving packet. Enter a value
between 1 and 4094.
src_ip_address
Specifies a source IPv4 address.
dst_ip_address
Specifies a destination IPv4 address.
mask
Specifies the mask of the IPv4 address.
proto_no
Specifies the value of a protocol field in a packet. The range is 1 to
255.
icmp_type
Specifies an ICMP message type. The range is 0, 3 to 5, and 8 to
18.
src_port_no
Specifies source TCP or UDP port numbers. The range is 0 to
65,535. To specify port numbers, use one of the following
formulas:
– eq src_port_no: Matches a packets whose port number is
equal to the specified port number.
– lt src_port_no: Matches packets whose port number is less
than the specified port number.
– gt src_port_no: Matches packets whose port number is
greater than the specified port number.
– ne src_port_no: Matches a packet whose port number is not
equal to the specified port number.
– range src_port_no src_port_no: Matches packets whose port
number is within the range.
dst_port_no
Specifies destination TCP or UDP port numbers. The range is 0 to
65,535. To specify port numbers, use one of the formulas listed for
the src_port_no parameter.
Mode
Hardware Access List mode