Allied Telesis AT-DC2552XS User Manual
Page 262
Chapter 11: Port Parameter Commands
262
Example
This command displays the current operational state of ports 1.0.1 to
1.0.4:
awplus# show interface port1.0.1-1.0.4
mtu
Indicates the maximum frame size that the switch
port can send and receive. For the management
port (eth0), it indicates the maximum packet size
that the management port can send and receive.
current duplex
Displays the current duplex mode when an
SFP+/QSFP+ module is connected.
current speed
Displays the current speed when an SFP+/
QSFP+ module is connected.
polarity
Displays the wiring configuration when an SFP+/
QSFP+ module is connected.
flowcontrol
Displays the state of flow control. This field is
only for the switch ports.
configured duplex
Displays the configured duplex mode when an
SFP+/QSFP+ module is connected.
configured speed
Displays the configured speed when an SFP+/
QSFP+ module is connected.
Unknown Ingress/
Multicast Blocking
Not supported.
Unknown Egress/
Multicast Blocking
Not supported.
SNMP link-status
traps
Displays the status of SNMP link traps on the
port. The options are:
Enabled: The port transmits SNMP
notifications.
Disabled: The port does not transmit SNMP
notifications.
input packets
Displays the numbers of packets received by the
port.
output packets
Displays the numbers of packets that the port
transmits.
Table 41. SHOW INTERFACE Command (Continued)
Field
Description