Allied Telesis AT-DC2552XS - Manual (Page 36)

Chapter 2: Management Session Commands
36 Section I: Switch Management
BAUD-RATE SET
Syntax
baud-rate set baud_rate
Parameter
baud_rate
Specifies the baud rate of the Console port in bps. The options are
1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200.
Mode
Global Configuration mode
Description
Use this command to set the baud rate of the Console port, which is used
for local management sessions of the switch. After changing the baud rate
of the Console port, change the baud rate of the Console terminal. These
two baud rates must be the same.
Confirmation Command
“SHOW BAUD-RATE” on page 60
Example
This example sets the baud rate of the Console port to 9600 bps:
awplus> enable
awplus# configure terminal
awplus(config)# baud-rate set 9600
Baud rate changed to 9600 bps.
Change your console baud correspondingly.
awplus(config)#