Allied Telesis AT-DC2552XS - Manual (Page 309)

AT-DC2552SX Switch Command Line Interface User’s Guide
Section II: Layer 2 Switching 309
NO SWITCHPORT TRUNK
Syntax
no switchport trunk
Parameters
None
Mode
Port Interface mode
Description
Use this command to change the ports to untagged ports and assign the
ports to the default VLAN1 if the ports are tagged ports. This command
changes the ports to the access mode so that you can configure the ports
as untagged ports.
This command is equivalent to the SWITCHPORT ACCESS VLAN
command. See “SWITCHPORT ACCESS VLAN” on page 318.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 116
Example
This example changes ports 1.0.23 and 1.0.24 to untagged ports and
assigns the ports to the default VLAN value of 1:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.23-port1.0.24
awplus(config-if)# no switchport trunk