Match mac-type – Allied Telesis AT-DC2552XS User Manual
Page 497
AT-DC2552SX Switch Command Line Interface User’s Guide
Section V: Security and Traffic Control
497
MATCH MAC-TYPE
Syntax
match mac-type l2bcast|l2mcast|l2ucast
Parameters
l2bcast
Specifies the Layer 2 Broadcast frames as the destination MAC
address type.
l2mcast
Specifies the Layer 2 Multicast frames as the destination MAC
address type.
l2ucast
Specifies the Layer 2 Unicast frames as the destination MAC
address type.
Note
All three keywords l2bcast, l2mcast, and l2uncast, start with the
letter “l” and the number “2” to represent Layer 2.
Mode
Class Map Configuration mode
Description
Use this command to add the type of destination MAC address as a
matching criterion to a class map. When the MAC address type has
already been assigned to a class map, this command replaces the
previous value with the new value.
When the MAC address type is assigned, the switch compares the MAC
address type against the Layer 2 address type of incoming frames.
To remove the MAC address type as a matching criterion from a class
map, use the NO MATCH MAC-TYPE command.
Confirmation Command