Allied Telesis AT-DC2552XS - Manual (Page 234)

Chapter 10: NTP Client Commands
234 Section I: Switch Management
SHOW NTP ASSOCIATIONS
Syntax
show ntp associations
Parameters
None
Modes
Privileged Exec mode
Description
Use this command to display the settings of the NTP client. See Figure 42
for information the command displays.
Figure 42. SHOW NTP ASSOCIATIONS Command
The information is described here:
Table 37. SHOW NTP ASSOCIATIONS Command
Field Description
Status Displays the status of the NTP client software on
the switch. The status can be either enabled or
disabled. If enabled, the switch seeks its date and
time from the NTP server. The default is disabled.
Server Displays the IP address of the NTP server. This
value is set with “NTP PEER” on page 232.
UTC Offset Displays the time difference, in hours and minutes,
between UTC and local time. This value is set with
“CLOCK TIMEZONE” on page 230.
Daylight Savings
Time (DST) Not supported.
NTP Configuration:
Status ........................ Enabled
Server ........................ 172.17.118.15
UTC Offset .................... -07:00
Daylight Savings Time (DST) ... Disabled