Allied Telesis AT-DC2552XS - Manual (Page 69)

AT-DC2552SX Switch Command Line Interface User’s Guide
Section I: Switch Management 69
TELNET
Syntax
telnet ipv4_address
Parameter
ipv4_address
Specifies the IPv4 address of a remote device you want to manage
using the Telnet client on the switch.
Mode
Privileged Exec mode
Description
Use this command to start a Telnet management session on a network
device that has an IPv4 address. You can manage one remote device at a
time.
Example
This example starts a Telnet management session on a network device
that has an IP address of 10.0.0.10:
awplus> enable
awplus# telnet 10.0.0.10