Allied Telesis AT-DC2552XS - Manual (Page 343)

AT-DC2552SX Switch Command Line Interface User’s Guide
Section II: Layer 2 Switching 343
REVISION
Syntax
revision revision_number
Parameter
revision_number
Specifies the revision number. The range is 0 to 255.
Mode
MST Configuration mode
Description
Use this command to specify the revision number of the current MST
configuration on the switch. Use the revision number to track the number
of times an MST configuration has been updated on the network.
Note
This command is available only when MSTP is enabled.
When you want a group of switches to belong to the same region, you
must assign the same MST region name and the same revision number to
these switches.
To restore the default revision number of 0, use the NO REVISION
command.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 116
Example
This example specifies the MST revision number as 4:
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree mode mstp
awplus(config)# spanning-tree mst configuration
awplus (config-mst)# revision 4