Allied Telesis AT-DC2552XS - Manual (Page 425)

425
Chapter 19
IGMP Snooping Commands
The IGMP snooping commands are summarized in Table 72.
Table 72. Internet Group Management Protocol Snooping Commands
Command Mode Description
“CLEAR IP IGMP” on page 426 Privileged Exec Clears all IGMP group membership
records.
“IP IGMP LIMIT” on page 427 Global
Configuration Specifies the maximum number of
multicast addresses the switch can
register.
“IP IGMP QUERIER-TIMEOUT” on
page 428 Global
Configuration Specifies the time period, in seconds,
used by the switch to identify inactive
host nodes and multicast routers.
“IP IGMP SNOOPING” on page 429 Global
Configuration Enables IGMP snooping on the
switch.
“IP IGMP SNOOPING MROUTER
INTERFACE” on page 430 Global
Configuration Manually identifies the ports where
multicast routers are connected.
“IP IGMP STATUS” on page 431 Global
Configuration Specifies the IGMP host node
topology, of either single-host per port
or multiple-host per port.
“NO IP IGMP SNOOPING” on
page 432 Global
Configuration Disables IGMP snooping on the
switch.
“NO IP IGMP SNOOPING MROUTER
INTERFACE” on page 433 Global
Configuration Removes multicast router ports.
“SHOW IP IGMP” on page 434 Privileged Exec Displays the IGMP snooping
configuration on the switch.
“SHOW IP IGMP HOSTLIST” on
page 435 Privileged Exec Displays the multicast router list on
the switch.
“SHOW IP IGMP MROUTER” on
page 436 Privileged Exec Displays the IGMP host list on the
switch.
“SHOW IP IGMP SNOOPING” on
page 437 Privileged Exec Displays the IGMP snooping
configuration, multicast router list, and
host list on the switch.