Allied Telesis AT-DC2552XS - Manual (Page 431)

AT-DC2552SX Switch Command Line Interface User’s Guide
Section IV: IPv4 Multicast 431
IP IGMP STATUS
Syntax
ip igmp status single|multiple
Parameters
single
Activates the single-host per port setting. Each port on the switch
has only one host. This is the default setting.
multiple
Activates the multiple-host per port setting. A port on the switch
can have multiple hosts.
Mode
Global Configuration mode
Description
Use this command to specify the IGMP host node topology as single or
multiple host per port. When receiving IGMP leave messages, the switch
responds depending on the IGMP host node topology specified.
Confirmation Command
“SHOW IP IGMP” on page 434
Examples
This example sets the host node topology to the single-host per port
setting:
awplus> enable
awplus# configure terminal
awplus(config)# ip igmp status single
This example sets the host node topology to the multiple-host per port
setting:
awplus> enable
awplus# configure terminal
awplus(config)# ip igmp status multiple