Allied Telesis AT-DC2552XS - Manual (Page 281)

281
Chapter 12
LACP Commands
The LACP port trunk commands are summarized in Table 47.
Table 47. LACP Port Trunk Commands
Command Mode Description
“CHANNEL-GROUP” on page 282 Port Interface Creates a new dynamic LACP trunk
group and adds ports to an existing
dynamic trunk group.
“LACP SYSTEM-PRIORITY” on
page 284 Global
Configuration Sets the LACP system priority value
for the switch.
“NO CHANNEL-GROUP” on
page 285 Port Interface Removes ports from the LACP trunk
group and deletes the trunk group.
“PORT-CHANNEL LOAD-BALANCE”
on page 286 Port Interface Sets the load distribution method to a
trunk group.
“SHOW ETHERCHANNEL” on
page 288 Privileged Exec Displays information about trunk
groups and LACP trunk groups on the
switch.
“SHOW ETHERCHANNEL DETAIL”
on page 290 Privileged Exec Displays detailed information about
the LACP trunk groups on the switch
“SHOW ETHERCHANNEL
SUMMARY” on page 293 Privileged Exec Displays the states of the member
ports of the LACP trunk groups.
“SHOW LACP SYS-ID” on page 295 Privileged Exec Displays the LACP priority value and
MAC address of the switch.
“SHOW PORT ETHERCHANNEL” on
page 296 Privileged Exec Displays the LACP port information.
“SHOW STATIC-CHANNEL-GROUP”
on page 300 Privileged Exec Displays information about static trunk
groups on the switch.
“STATIC-CHANNEL-GROUP” on
page 302 Port Interface Creates a new static trunk group and
adds ports to an existing static trunk
group.