Allied Telesis AT-DC2552XS - Manual (Page 102)

Chapter 4: Basic Switch Operations Commands
102 Section I: Switch Management
RELOAD
Syntax
reload
Parameters
None
Mode
Privileged Exec mode
Description
Use this command to reset the switch. This command is identical to
“REBOOT” on page 101.
The command displays a confirmation prompt.
Caution
The switch does not forward network traffic while it initializes its
management software. Some network traffic may be lost.
Note
The switch discards any configuration changes that have not been
saved. To save your changes, enter the WRITE command or the
COPY RUNNING-CONFIG STARTUP-CONFIG command before
resetting the switch. See “WRITE” on page 156 or “COPY
RUNNING-CONFIG STARTUP-CONFIG” on page 149.
Example
This example resets the switch:
awplus> enable
awplus# reload