Ip address – Allied Telesis AT-DC2552XS User Manual
Page 404
Chapter 17: IPv4 Management Address Commands
404
IP ADDRESS
Syntax
ip address
ipaddress
/
mask
Parameters
ipaddress
Specifies a management IPv4 address for the switch.
mask
Specifies the subnet mask for the address.
Mode
VLAN Interface mode
Description
Use this command to manually assign an IPv4 management address to an
VLAN interface and the management Ethernet port eth0. You can assign
one IPv4 address for one VLAN and one IPv4 address for the eth0 port.
The two IPv4 management addresses, assigned to a VLAN interface and
the management Ethernet port eth0, must be IPv4 addresses that belong
to different networks. For example, if you assign 192.168.2.10/24 to VLAN
1, you cannot assign any addresses in the 192.168.2.0/24 network to the
eth0 port.
When you want to change the IPv4 address assignment, you must delete
the IPv4 address using the NO IP ADDRESS command and reassign a
new IPv4 address. See “NO IP ADDRESS” on page 409.
To assign the switch an IPv4 address from a DHCP server, refer to “IP
ADDRESS DHCP” on page 406.
Confirmation Command