Allied Telesis AT-DC2552XS - Manual (Page 90)

Chapter 4: Basic Switch Operations Commands
90 Section I: Switch Management
BANNER LOGIN
Syntax
banner login
Parameters
None
Mode
Global Configuration mode
Description
Use this command to configure the login banner. The message is
displayed prior to the login user name and password prompts. If the switch
also has a message-of-the-day banner, this message is displayed second.
After you enter the command, the prompt “Type CTRL/D to finish” is
displayed on your screen. Enter a login message of up to 3,999
alphanumeric characters. Spaces, special characters except “!” and “?,”
and carriage returns are allowed. When you are finished, hold down the
CTRL key and type D.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 116
Example
This example creates a login banner:
awplus> enable
awplus# configure terminal
awplus(config)# banner login
Type CTRL/D to finish
This switch is located in building B on the second floor,
wiring closet 2B.