Allied Telesis AT-DC2552XS - Manual (Page 277)

AT-DC2552SX Switch Command Line Interface User’s Guide
Section II: Layer 2 Switching 277
SHUTDOWN
Syntax
shutdown
Parameters
None
Mode
Port Interface mode
Description
Use this command to disable ports. When you disable a port, the port
status changes to the link-down state and the port does not forward traffic.
You may want to disable unused ports to secure them from unauthorized
use. In addition, you want to disable ports that are having problems with
network cables or their link partners. The default setting for the ports is
enabled.
To reactivate a port, refer to “NO SHUTDOWN” on page 254.
Confirmation Command
“SHOW INTERFACE” on page 260
Example
This example disables ports 1.0.15 and 1.0.16:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.15,port1.0.16
awplus(config-if)# shutdown