Allied Telesis AT-DC2552XS - Manual (Page 244)

Chapter 11: Port Parameter Commands
244 Section II: Layer 2 Switching
EGRESS-RATE-LIMIT
Syntax
egress-rate-limit value
Parameter
value
Specifies the maximum amount of traffic that can be transmitted
from the port. The value is kilobits per second. The range is 1 to
40,000,000 kbps. The maximum rate for 10G ports is 10,000,000
kbps.
Mode
Port Interface mode
Description
Use this command to set a limit on the amount of traffic that can be
transmitted per second from the port. By default, the value is not specified.
When you specify a value, which is not an increment of 64, the switch
rounds up the specified value to an increment of 64.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 116
Example
This example sets the egress rate limit to 8,000 kilobits per second on port
1.0.13:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.13
awplus(config-if)# egress-rate-limit 8000