Allied Telesis AT-DC2552XS - Manual (Page 256)

Chapter 11: Port Parameter Commands
256 Section II: Layer 2 Switching
PURGE
Syntax
purge
Parameters
None
Mode
Port Interface mode
Description
Use this command to restore the default settings configured with the
following commands:
 “CUT-THROUGH” on page 242
 “DESCRIPTION” on page 243
 “EGRESS-RATE-LIMIT” on page 244
 “FLOWCONTROL RECEIVE” on page 245
 “SHUTDOWN” on page 277
 “SNMP TRAP LINK-STATUS” on page 214
 “STORM-CONTROL” on page 278
Confirmation Command
“SHOW RUNNING-CONFIG” on page 116, “SHOW INTERFACE” on
page 260, “SHOW FLOWCONTROL INTERFACE” on page 258, “SHOW
INTERFACE STATUS” on page 265, and “SHOW STORM-CONTROL” on
page 275
Example
This example restores the default settings to ports 1.0.5, 1.0.6 and 1.0.12:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.5,port1.0.6,port1.0.12
awplus(config-if)# purge