Vlan macaddress – Allied Telesis AT-DC2552XS User Manual
Page 329
AT-DC2552SX Switch Command Line Interface User’s Guide
329
VLAN MACADDRESS
Syntax
vlan
vid
name
name
type macaddress
Parameters
vid
Specifies a VLAN identifier in the range of 2 to 4094. VID 1 is
reserved for the Default_VLAN. You can specify only one VID.
The VID of a VLAN must be unique in a network, unless a VLAN
spans multiple switches, in which case its VID should be the same
on all switches on which the VLAN resides. For example, to create
a VLAN that spans three switches, you assign it the same VID
value on each switch.
name
Specifies a name of up to 20 characters for the VLAN. The first
character of the name must be a letter; it cannot be a number.
VLANs are easier to identify if their names reflect the functions of
their subnetworks or work groups (for example, Sales or
Accounting). A name cannot contain spaces or special characters,
such as asterisks (*) or exclamation points (!). A name must be
unique on the switch for a VLAN that is only on one switch. A VLAN
that spans multiple switches must have the same name on each
switch.
Mode
VLAN Configuration mode
Description
Use this command to create a MAC address-based VLAN. You can create
only one VLAN at a time.
After creating a VLAN, use “SWITCHPORT ACCESS VLAN” on page 318
to add MAC addresses to it and “VLAN SET MACADDRESS (Port
Interface Mode)” on page 333 to assign the address to egress ports.
Confirmation Command