Allied Telesis AT-DC2552XS - Manual (Page 155)

AT-DC2552SX Switch Command Line Interface User’s Guide
Section I: Switch Management 155
SHOW STARTUP-CONFIG
Syntax
show startup-config
Parameters
None
Modes
Privileged Exec mode
Description
Use this command to display the contents of the boot configuration file.
The boot configuration file is the startup configuration file that the switch
uses to configure itself when the switch is power-cycled or reset. The
startup configuration file is the file that you specify with the BOOT
CONFIG-FILE command. By default, the startup configuration file is the
boot.cfg file. See Figure 31 for an example of this file.
Figure 31. SHOW START-UP CONFIG Command
Example
This example display the contents of the boot configuration file:
awplus# show startup-config
!
service maxmanager 3
baud-rate set 115200
...
mac address-table ageing-time 300
!
service password-encryption
!
username manager privilege 15 password 8 3af00c6cad11f7ab5db4467b66ce503e
!
!
endawplus#