Static-channel-group – Allied Telesis AT-DC2552XS User Manual
Page 302
Chapter 12: LACP Commands
302
STATIC-CHANNEL-GROUP
Syntax
static-channel-group
id_number
Parameter
id_number
Specifies the ID number of a static trunk group. The range is 1 to
32.
Mode
Port Interface mode
Description
Use this command to create a new static trunk group or to add ports to an
existing static channel group. You can create up to 32 trunk groups on the
switch, including dynamic LACP and static trunk groups.
To create a new static trunk group or add ports to an existing static trunk
group, the member ports must belong to the same VLAN and have the
same switchport mode: either access or trunk.
When you specify a static trunk group in the command line, add the prefix
“sa” to the ID number. For example, A static trunk group with the ID
number 3 is “sa3.”
To remove the port from the static trunk group, use the NO STATIC-
CHANNEL-GROUP command.
Note
If you delete all the member ports from the LACP trunk group, the
LACP trunk group is deleted automatically.
Confirmation Command