Allied Telesis AT-DC2552XS - Manual (Page 249)

AT-DC2552SX Switch Command Line Interface User’s Guide
Section II: Layer 2 Switching 249
INTERFACE
Syntax
interface port_ids |sa X |po X |eth0
Parameters
port_ids
Specifies a port ID or multiple port IDs. Use a comma (,) to
separate port IDs and a hyphen (-) to indicate a range of port IDs.
sa X
Specifies a static port trunk ID or multiple static port trunk IDs
where X indicates the number of the port trunk ID. Use a comma (,)
to separate port IDs and a hyphen (-) to indicate a range of port
IDs.
po X
Specifies a dynamic port trunk ID or multiple dynamic port trunk
IDs where X indicates the number of the port trunk ID. Use a
comma (,) to separate port IDs and a hyphen (-) to indicate a range
of port IDs.
eth0
Specifies the management Ethernet port.
Mode
Global Configuration mode
Description
Use this command to move from the Global Configuration mode to the
Port Interface mode to configure ports. When configuring dynamic and
static trunk groups, specify this command with the saX or poX parameter.
Examples
This example moves to the Port Interface mode to configure ports 1.0.1
through 1.0.10:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.1-1.0.10